 IWeb
Administrator Guide
|
Scheduled Reports Properties
Authorized users can access the Scheduled Reports properties by clicking on the Administration > Settings > Properties link, then clicking on the Scheduled Reports category heading.
To configure the settings, enable (select) or disable (deselect) the options, enter any required information, and click Save at the bottom of the page. Changes affect users the next time they log in to the application or module.
Click Reset to erase new or updated entries and reset them as they were after the last submit was done.
The options and fields on this page are as follows:
| Option/Field | Description | |
|
Blocked Hours: Non-Registry Clients (0-23, comma-separated) |
Enter whole numbers separated by commas to represent the available hours for users to schedule reports to run. This setting only affects non-Registry Client users. |
|
|
Blocked Hours: Registry-Wide (0-23, comma-separated) |
Enter whole numbers separated by commas to represent the available hours for users to schedule reports to run. This setting reflects all of the system's downtimes. |
|
|
Email Text |
Enter the text that appears in the body of UFM messages (emails). |
|
|
IWeb Address |
Enter the IWeb root location URL for UFM reports to run. This should be the location of the Tomcat server.
|
|
|
Output Folder |
Enter the file path for the location on the hard drive where the generated reports are to be stored. |
|
|
Proxy Server Address |
Enter the proxy server URL address, if applicable. |
|
|
Reply-to Email Address |
Enter the reply-to (From) email address for the scheduled reports. |
|
|
Zip Report Output Before Emailing |
Select this option to zip the report output before attaching it to the email. |
|
 |